Nowadays many houses have more than one bathroom. Other types of buildings to be taken into consideration are commercial buildings. Commercial buildings often prove to be quite valuable in providing profit to the heating installer.
The most obvious solution to many in these scenarios would be to take a simple upsizing approach and fit a bigger storage cylinder.
However, there is an alternative which could work well for all the parties concerned. The customer will feel satisfied with a better service and the installer's life will feel much easier and more profitable.
Continuous-flow water heating in the home
This type of technology is called continuous-flow water heating. Traditionally, gas has always been relatively cheap and insulation standards have been low. Therefore, up until now, consumers have not had to worry about water heating being a cost issue. They never sought to pay much attention to design and installation.
This has now completely changed as there are better insulation standards. This has resulted in bringing lower heat requirements to the point where year-round heating consumption is about equal to, or even below the DHW requirement. Improvements in building regulations over the next few years has made the economics of water heating even more important.
Changing needs amongst consumers
Consumers are now becoming more aware of what they need and this has greatly impacted their hot water requirement levels. A survey was conducted by a leading manufacturer asking about requirements for a customer's bathroom. Many of the responses received detailed a wish for a better water service.
Many of the consumers desired more power in the showers, walk in showers, bigger baths, and separate showers. It became quite apparent from the survey that consumers are very keen to invest a lot of time and money on the bathroom they want.
Unfortunately, many consumers in wanting their dream bathroom fail to take in the realities of the situation. Mainly they fail to consider whether or not their water and heating system will actually deliver the service that matches their expectations. It must be realised that combis and two shower and bath home cannot cope, particularly during the winter season.
A four person household would put immense pressure on the water usage. A lot of water will get used during the morning rush hour and it is likely that the washing machine and the dishwasher will also be on the go.
However, the problems facing households are just minuscule compared to larger buildings such as commercial buildings. For instance, in a hotel or nursing home, if the hot water supply fails then this could lead to disastrous consequences for all concerned.
There are some manufacturers that provide a solution to this type of problem. One model is a fanned-flued wall mounted appliance. The main feature is that it can deliver up to 54kWh directly into water with a controlled system that ensures that the water temperature remains within the" of the required flow whatever other demands are made for hot water.
As water supplies are higher than ever before, it's time to look for a modern solution.
By Tal Potishman
Article Source: http://EzineArticles.com/3260155
0 comments:
Post a Comment